-
Archives
- January 2018
- October 2017
- September 2017
- August 2017
- July 2017
- May 2017
- January 2017
- April 2014
- December 2013
- November 2013
- May 2013
- April 2013
- March 2013
- February 2013
- January 2013
- December 2012
- November 2012
- September 2012
- August 2012
- July 2012
- June 2012
- May 2012
- April 2012
- March 2012
- February 2012
- December 2011
- November 2011
- October 2011
- September 2011
- August 2011
- May 2011
- March 2011
- February 2011
- November 2010
- September 2010
- August 2010
- July 2010
- June 2010
- March 2010
- February 2010
- January 2010
- December 2009
- November 2009
- February 2009
- October 2008
- September 2008
- August 2008
- July 2008
-
Meta
Category Archives: Electronics
Temperature Differential sensor
I plan to construct an Arduino circuit which will read two temperature sensors, and turn on a relay if the differential gets too large. This is eventually to be pressed into service on the dew heaters for the telescope. But … Continue reading
hardware RNG
Seems like you should be able to pull truly random numbers out of a hardware circuit. Tune into the CMB or some other kind of noisy circuit, sample it, and voila, all the random you can eat. hm. Needs thought.
Posted in Electronics
Leave a comment
keypad to PIC using only one pin
http://www.edn.com/article/469869-Single_wire_keypad_interface_frees_microcontroller_I_O_pins.php
Posted in Electronics, Making
Leave a comment
555 metronome circuits
http://www.edn.com/article/CA46074.html http://www.ecelab.com/circuit-metronome.htm
Posted in Electronics, Making
Leave a comment
What was I trying to build?
I was going through an old project notebook, and ran into the following entry: “I’ve been trying to figure out how to build avoltage attenuator for a couple of years, and my current brain exercise is to make a circuit … Continue reading
Posted in Electronics, Making, Random Thoughts
Leave a comment
bear unicycle switch
http://www.discovercircuits.com/DJ-Circuits/onoffwtimeout.htm
Posted in Electronics, Making
Leave a comment