-
Archives
- January 2018
- October 2017
- September 2017
- August 2017
- July 2017
- May 2017
- January 2017
- April 2014
- December 2013
- November 2013
- May 2013
- April 2013
- March 2013
- February 2013
- January 2013
- December 2012
- November 2012
- September 2012
- August 2012
- July 2012
- June 2012
- May 2012
- April 2012
- March 2012
- February 2012
- December 2011
- November 2011
- October 2011
- September 2011
- August 2011
- May 2011
- March 2011
- February 2011
- November 2010
- September 2010
- August 2010
- July 2010
- June 2010
- March 2010
- February 2010
- January 2010
- December 2009
- November 2009
- February 2009
- October 2008
- September 2008
- August 2008
- July 2008
-
Meta
Monthly Archives: September 2012
CNC, another satisfied customer
My Mom asked me to cut new house numbers for her triplex. A couple of the old numbers got broken when she had the house painted last summer. After a bit of negotiation, we agreed that it would be difficult … Continue reading
CNC, first project!
Well, that was satisfying. I finally used the new CNC machine “in anger” and cut out a “real” project. I’d been thrashing around, trying to convince myself that I wasn’t just procrastinating, and after a couple of hours of messing … Continue reading
CNC, Super-PID installation continues
As I was looking around for something else today, I ran across the spare motor controller for the G540, and decided to install it before I put the computer back together fully. It was another uninstallation of the G540, but … Continue reading
CNC, G540 ports full
I finally decided to bite the bullet and get the wiring run from the G540 to the Super-PID. The Super-PID will ride on the Y gantry, as that will bring it close to the places it needs to be without … Continue reading
UAV project underway
I finally decided to bite the bullet and buy an RC airplane so that I can start thinking more seriously about making a UAV someday. In order to do a UAV, I’m going to need to understand a little more … Continue reading
CNC – accessory design
I’m starting to be up against a time limit with the CNC again; if I want to get Halloween decorations cut for this year, I can start with the already-working machine, but everyone involved will be a lot happier if … Continue reading